Services: E-mail Services

    Shared Access Printers in LIT Building 134

    There are shared network printers in the corridors of the building. From the table below,
    select the IP addresses of the printers closest to you and set up access according to the instructions for your operating system.

    Windows 7

      Control Panel->Hardware & Sound->Printer Setup.
      Add a network, wireless or bluetooth printer.
      The printer you are looking for is not on the list.
      Add a printer by its TCP/IP address or host name.
      Enter the corresponding IP address into the Name or IP address field.
      The drivers are located here \\mirror\pub\DRV\Printer\Lexmark\DRIVERS.
      Printer model - Lexmark MX720 Series XL.

    Windows 10

      Settings->Devices->Printers and Scanners->Add Printer or Scanner.
      No printer or scanner in the list.
      Add a printer by its TCP-IP address.
      The drivers are here \\mirror\pub\DRV\Printer\Lexmark\DRIVERS.
      Printer model - Lexmark MX720 Series XL.

    Network addresses of shared printers

    West (Administration) Wing:

      2-nd floor - 192.168.12.3 (side.200)
      3-rd floor - 192.168.40.3
      4-th floor - 192.168.40.4
      5-th floor - 192.168.40.5 ! Disconnected while the floor is being renovated

    East (buffet) Wing:

      3-rd floor - 192.168.44.3
      5-th floor - 192.168.44.5

    Scanning

    Only scan to flash drive and scan to email modes are available.

    !!! Network scanning mode is not available !!!

      1) Scan to Flash Drive:

      - Place your original document on the scanner glass,
      - Plug your USB Flash Drive into the USB port on the right side of the control panel,
      - Press the "USB Mass Storage Device" icon on the scanner panel,
      - Click on "Scan to USB",
      - Type a name for the file into which the result of the scan will be written,
      - Wait till the scanning process will finish and press the "Finish the job" button,
      - Pull out USB flash drive.

      2) Scan to email the result:

      - Place the original document on the scanner glass,
      - Click on the E-mail icon,
      - Enter your email address in the "To" field,
      - Click "Send" and wait until scanning is finished,
      - Click "Send".

    If you have any problems with the setup, write to noc@jinr.ru or call tel. 216-34-88.